Serve in mind that while you can do this yourself, hiring a beneficial electrician is recommended if you’re dark doing this, as electricity can raze you (or at least, with 120 volts, really, really wound) .
The steps to
installation Insteon Switch are as follows:
- Turn off the power. Don’t forget this one. Any time you’re “in the box” from the moment you bear the switch camouflage to the moment you carry out it benefit on, be cognizant of whether the power is on or not. Unless the power needs to be on so you can test the lines with a multimeter, the power should ALWAYS be off so you can work safely.
- Derive the weak switch. This beautiful involves removing the faceplate and mounting screws. Inside you’ll likely obtain a couple of wires connected to the switch with wire nuts; disconnect those and engage the aged switch.
- Identify the line, load, neutral, and ground wires. This is the hardest share, interesting turning the power relieve on and using a multimeter to test the lines. Generally (but not always), the “line” (power coming from the street) is murky and the “load” (the power going to the light) is red. The “neutral” wire – which might not have even been connected to the fresh switch, but often sits in a bundle at the serve of the box – is likely white, for “ground” wire in bare metal. Without getting too technical, the neutral wire is a key component that allows a switch to communicate on mesh network over the power lines, but some older houses may not have that wire in the switch boxes. However, that doesn’t mean you’re out of luck. It unbiased means you’ll need a switch like the SwitchLinc 2-Wire RF Dimmer, which can calm control the light but communicates to other devices wireless rather than to the power line infrastructure in the house.
- Connect Insteon switch. Once you have the wires identified, connect using wire nuts to labelled wires on switch.
- Mount the switch. Next, you’ll enact everything support in the switch box and screw the switch and faceplate support on.
- Turn the power wait on on. After turning the power benefit on at the breaker, the LEDs on the switch should light up.
- Test the switch. Now you should be able to assume the switch like any other, turning the light.
- Add switch on Insteon Network. We discussed the basics about this with the ApplianceLinc, but it involves holding the switch down to develop it in Linking Mode, then adding it to your ISY-994i.
Installing an
Insteon switch Video